 |
| All Mirror
Panels come with two pre-installed aluminum angle brackets for wall
mounting. Remove these brackets if you are using the Alvas mirror
base. Keep the clear plastic sheet over the mirror face to protect
it while mounting the bases. |
| |
| 1) Open 'X'
Brace and secure ends to nuts on 'T' Bars using the 4 Hex bolts
provided. Put Hex Bolts in all the way but only finger tight to
allow adjustment when attaching Bumper Guard. |
| |
| 2) Attach Bumper
Guard to tabs in 'T' Bars using the 4 Countersink Bolts provided.
Place rounded corner of Bumper Guard away from vertical square tube
of 'T' Bar. Tighten these Countersink Bolts completely with a #2 Phillips-head
screwdriver. |
| |
| 3) Now tighten
the 4 Hex Bolts with a 9/16" wrench. |
| |
| 4) Have a helper
hold Mirror Panel centered on base. Side edges of mirror frame should
be centered and flush with side vertical edges of the 'T' Bar. Drill
drive four 1 1/2" Self-drilling Screws through the holes in
vertical square tube of 'T' Bar and Mirror Panel's aluminum frame.
Tighten screws up to the point where the sponge pads on 'T' Bar
begin to slightly compress. Do not press excessively on mirror surface.
Be careful not to over tighten screws to avoid stripping. |
| |
| 5) Plastic
protective cover may now be removed from Mirror Panel. |
| |
6) Drill drive three 3/4" Self-drilling Screws through the
holes in bottom of Bumper Guard, securing the Bumper Guard to the
bottom of Mirror Panel frame. Do not over-tighten screws.
|
