Alvas Low Rolling Glassless Mirror

- Assembley Instructions -

Tools Needed 1/2" Wrench Battery Powered Drill Screwgun with #2 phillips screw bit #3 phillips screwdriver One Helper

Contersunk Machine Screws (4)	1 1/2" Self-Drilling Screws (4)	3/4" Self-Drilling Screws (1)

All mirrors come with two preinstalled aluminum angle brackets for wall mounting.
Remove these brackets if you are using the Alvas mirror base.
Keep the clear plastic sheet over the mirror face to help protect it while mounting the bases.
Remove the tape from the plastic cover on the bottom edge of the mirror panel before
mounting mirror panel to the frame. Mirror Panels sit approximately 4” from floor.

---

1) Attach Bumper Guard to short tabs in T-Bars using the four countersunk screws provided. Place rounded corners of Bumper Guard away from square tube of T-Bar. Tighten these countersunk screws completely with a #3 Phillips-head screwdriver. 2) Hand tighten wheels to the welded nuts on the bottom of the T-Bar, then use a 1/2” wrench to securely tighten wheels. 3) Have a helper hold Mirror Panel centered on base with plastic cover still taped on face (Remove tape from plastic only on side where you are screwing.) Side edges of mirror should be centered and flush with ends of the bumper plates. 4) Use screw gun with #2 bit to drive four 1 1/2“ self-drilling screws through the vertical square tube on T-Bar into the Mirror Panel’s aluminum frame to secure Mirror Panel to T-Bar. Be careful not to over tighten screws. Sponge Pads will help to keep them from being stripped. Do not push excessively on mirror surface. 5) Use screw gun with #2 bit to drive one 3/4” self-drilling screw through the hole in bottom center of Bumper Guard. This secures Bumper Guard to bottom of Mirror Panel. Do not over tighten screws. 6) Plastic protective cover may now be removed from Mirror Panel.

---