Free
Standing Ballet Barres (14' & 16') |
| YOU
SHOULD HAVE: |
|
|
For
single-sided unit |
|
For
double-sided unit |
| - |
one
14' or 16' Wood Barre |
|
- |
two
14' or 16' Wood Barres |
| - |
one
large folding X-Brace |
|
- |
one
large folding X-Brace |
| - |
one
folding Y-Brace |
|
- |
one
folding Y-Brace |
| - |
three
41" long Uprights |
|
- |
three
41" long Uprights |
| - |
three
30" long Legs |
|
- |
three
30" long Legs |
| - |
three
9" "Extension Studs" |
|
- |
six
9" "Extension Studs" |
| - |
three
large wing Nuts |
|
- |
six
large wing Nuts |
| - |
three
Square Nuts and three Washers |
|
- |
six
Square Nuts and six Washers |
| - |
six
3/8" Bolts and six small wing Nuts |
|
- |
six
3/8" Bolts and six small wing Nuts |
|
| _____________________________________________________ |
| SETTING
UP THE BASE: |
| - |
Bolt
on the three Legs to the three Uprights with the 3/8"
bolts provided |
|
THE
BASE SHOULD LOOK LIKE THIS: |
| - |
Unfold
the X-Brace and fasten one end to the two studs on one Upright
and the other end to the two studs on the other Upright with
the small wing nuts provided |
|
 |
| - |
Connect
the Y-Brace to the remaining Leg/Upright unit with the small
wing nuts. The single end of the Y-Brace connects to the botoom
stud of the Leg/Upright that's in the middle. (See Drawing) |
|
| _____________________________________________________ |
| PUTTING
THE BARRE ASSEMBLIES TOGETHER: |
 |
|
Screw the Extension Studs into the holes in the Wood Barres clockwise
by hand until the shoulders touch the wood. An additional
1/2 turn may be necessary to straighten out the Extension
Studs and make them all perpendicular to the Wooden Barre
and parallel to each other. Screw on wing Nuts, Washers, and Square Nuts exactly as
shown in illustration. |
| _____________________________________________________ |
| MOUNTING
BARRE ASSEMBLY: |
| Pick
up bar assembly and slide the Square Nut, on the end of each
Extension Stud, into the top slot of its corresponding Channel.
(Washers and Wing Nuts are outside.) Tighten the wing Nuts
when the barre is at your desired height. To adjust barre,
loosen the |
|
wing Nut and slide it up and down the Channel, then retightens
the Wing Nut. Grab the Wood Barre at the point where the
Extension Stud screws in and wiggle the barre up and down
when tightening and loosening the wing Nut. |
ALSO
AVAILABLE:4', 6', 8' and 10' Free Standing Ballet Barres |
